Support Bar Question

HorrorGuy

Learning the Ropes
Joined
Nov 11, 2016
Messages
48
Reaction score
4
Points
8
Location
South Jersey
Finialy working on my Vetter Terraplane project.Put it up on a table which force me to squeeze by it everytime I was in the garage.There are supports under the the top half of the body .The one end of the supports are angled.I am guessing that that end bolts to the roll bar.Since I haven't seen an exploded diagram is that the way they are supposed to hooked up ?
 
Searching through images on the internet I found my answer to this question.A bunch of pictures on a restoration of a Terraplane.
 

Attachments

  • answered1.jpg
    answered1.jpg
    80.9 KB · Views: 256
  • answered.jpg
    answered.jpg
    68.8 KB · Views: 230
Yes. Hopefully those pics were taken by someone who has it assembled correctly. If the assembly is not correctly (correct bar on correct side, bar inside mounting tab on main frame vs outside the mounting tab, bolt head out/nut in vs nut out/bolt head in), the top body half will interfere. Sorry, but I did not save pics after sorting out my interference issues.
 
That I will be finding out shortly.The upper body on mine is on with tie straps because it was unfished project when i got it .I am hoping to take that off next week .
 
Back
Top