Saxonplace
Vetter Aficionado
Hi, just added photo's of my Z1000ST trunk project, awaiting sheet metal to construct mounting plate before final fixing.
Z1000ST Trunk
- Thread starter Saxonplace
- Start date
Kynan C.
Admin
Looks sharp Saxon! Really like the paint.
Welcome to the forum! You can also post images in the threads, just use the attachment feature below titled "Upload a File".
Looking forward to more updates.
Welcome to the forum! You can also post images in the threads, just use the attachment feature below titled "Upload a File".
Looking forward to more updates.
brianinpa
Five Star Vetteral
Welcome to the forum. Vetter trunk's look good on anything... I've even seen one on a Helix.
Saxonplace
Vetter Aficionado
Thanks for the comments, all completed now, extra photos added.
brianinpa
Five Star Vetteral
Inquiring minds want to know... where did you get the green mounts?
Saxonplace
Vetter Aficionado
Inquiring minds want to know... where did you get the green mounts?
Saxonplace
Vetter Aficionado
Hi they are called Stauff clamps, had some from when I worked for an engineering company. They are normally used to hold industrial pipework.
This is their website in the USA http://www.stauffusa.com/
You do sometimes see them on Ebay as well but normally quite pricey.
They are excellent quality for holding pipework but at a price!
This is their website in the USA http://www.stauffusa.com/
You do sometimes see them on Ebay as well but normally quite pricey.
They are excellent quality for holding pipework but at a price!
Saxonplace
Vetter Aficionado
I have been looking at the wiring, its got a 2 pin plug so I have wired up the rear light bulbs to the tail light and they work fine, the yellow wires for the 21w stop lamps have been cut off very short (at manufacture I assume), is this normal?
Don't know if this was done on certain orders to reduce battery drain?
Don't know if this was done on certain orders to reduce battery drain?
brianinpa
Five Star Vetteral
Only a 2 pin plug? I think it should be 4: left, right, brake, and ground.
Kynan C.
Admin
The mounting is clean! Nice job.
Saxonplace
Vetter Aficionado
The plug and socket have 3 holes but only 2 are wired, maybe because it was made for export to the UK as we do not have red indicator signals here, they would have to be amber.
Saxonplace
Vetter Aficionado
Thanks for that, would have been easier if the trunk mounting points were the same distance apart front and rear.
Also its a 4mm thick plate which was maybe a bit over the top!
Similar threads
